1º Place the cover as if it were a sock, and insert the rigid piece that you will find inside the cover ⓵, between the backrest and the seat.

2º If your seat has armrests, insert them through the side Velcro openings, and the backrest adjustment wheel through the circular opening ⓶. Finally, pull the tensioner located at the bottom of the cover to tighten it ⓷ and tie the elastic cord end to the seat adjustment bar ⓸ to prevent the cover from moving.

3rd If you have any pocket organizer or accessory hanging from the headboard, use the rear opening to access the headboard supports ⓹

1º Distinguish between the right armrest (Right 🟢) and left armrest (Left 🔴) for each armrest according to its side.

2º Place the cover as if it were a sock, and insert the armrest through the opening all the way to the end, leaving the opening for the armrest shaft.

1º Put the cover on as if it were a sock, and insert the 2 rigid pieces that you will find inside the cover ⓵, between the backrest and the seat.

2º Insert the backrest adjustment wheel through the circular opening ⓶. Finally, pull the tensioner located at the bottom of the cover to tighten it ⓷ and tie the elastic cord end to the seat adjustment bar ⓸ to prevent the cover from moving.

3rd If you have any pocket organizer or accessory hanging from the headboard, use the rear opening to access the headboard supports ⓹

4th If your seat has isofix, you can access it by finishing opening the pre-cut openings in the area marked for the isofix.

1º Put the cover on as if it were a sock, and insert the 2 rigid pieces that you will find inside the cover ⓵, between the backrest and the seat.

2º Insert the headers through the upper openings ⓶. Finally, pull the tensioner located at the bottom area of the cover to adjust it ⓷ and ⓸.

3rd If your seat has isofix, you can access it by finishing opening the pre-cut openings in the area marked for the isofix.

1º Place the cover as if it were a sock, and insert the 3 rigid pieces that you will find inside the cover ⓵, between the backrest and the seat.

2º Insert the headers through the upper openings ⓶. Finally, pull the tensioner located at the bottom area of the cover to adjust it ⓷ and ⓸.

Pull the side recline straps through the openings and place the included ring on the strap to prevent it from slipping inside the cover. On the California Ocean and Beach, thread the central strap for making the bed through the opening until the strap is completely pulled out.

3rd If your seat has isofix, you can access it by finishing opening the pre-cut openings in the area marked for the isofix.

1º Put the cover on as if it were a sock, and insert the 2 rigid pieces that you will find inside the cover ⓵, between the backrest and the seat.

2º Insert the backrest adjustment wheel through the circular opening ⓶. Finally, pull the tensioner located at the bottom of the cover to tighten it ⓷ and tie the elastic cord end to the seat adjustment bar ⓸ to prevent the cover from moving.

3rd If your seat has isofix, you can access it by finishing opening the precut openings in the area marked for the isofix.

1st Place the cover on like a sock, and insert the rigid piece you will find inside cover ⓵, between the backrest and the seat.

2nd Insert the headboards through the upper openings ⓶. Finally, pull the tensioner you will find at the lower part of the cover to adjust it ⓷ and ⓸.

3rd If you use ISOFIX, you can access it by fully opening the pre-cut openings in the area marked for ISOFIX.